(PDF) HPE Master ASE HPE0-J58 Exam and Certification Test Engine
Use HPE0-J58 Exam Dumps (2023 PDF Dumps) To Have Reliable HPE0-J58 Test Engine
NEW QUESTION 47
How does the HPE Nimble Storage product strategy support a customer's investment protection requirements
for today and the future?
- A. by supporting the implementation of third party cache, spinning media, and flash media
- B. by supporting replication between current and previous-generation array models
- C. by supporting the repurposing of obsolete array controllers as high-density servers
- D. by supporting replication with arrays from other vendors
Answer: A
NEW QUESTION 48
A customer has two data centers in a metropolitan area. The link between the data centers is IP-based and satisfies the bandwidth and latency requirements. They have the following requirements:
Transparently and automatically failover and fall back between sites
Provide block and file access
Block access must provide connectivity for fibre channel and iSCSi hosts
All-Flash storage solution
You plan to propose a design based on HPE 3PAR storage arrays.
What would be the most cost-effective model that meets the customer needs?
- A. HPE 3PAR 20850
- B. HPE 3PAR 8450
- C. HPE 3PAR 20450
- D. HPE 3PAR 9450
Answer: B
NEW QUESTION 49
A customer has an HPE 3PAR 7400 running 3.2.1 MUG with 64 drives using the original licensing model. The customer needs to add an additional 32 drives, instead or purchasing the individual drive licenses, the customer asks about using the newer All-Inclusive licensing model for the array.
What should you inform them about their licensing model options?
- A. All-inclusive licenses are not available for their array
- B. They can switch to All-inclusive when they upgrade to 3.2.2 MU3.
- C. They can switch to All-inclusive for minimal cost.
- D. All-Inclusive licenses require a minimum of 128 drives
Answer: A
NEW QUESTION 50
A customer needs to new storage solution, including replication. The replication solution does not need to provide an RTO or RPO of zero.
The customer suffers from severe VM sprawl and has experienced unidentified storage service-level degradations.
What should you point out during your presentation of the solution?
- A. Hardware-assisted parity generation and deduplication mitigate the changing performance requirements
- B. When a storage system is being overloaded, the replication software will automatically move the workload
- C. VMs are always individually visible to the array with automatic enablement of VVOL technology
- D. InfoSight and VM details would help in identifying misbehaving VMs putting a high load on the array
Answer: C
NEW QUESTION 51
A customer has two HPE SPAR arrays with synchronous replication configured.
I he customer established a new location less than 10 km away that will he used for disaster recovery. The data at the disaster location does not need to be as currant as the data at the primary location. The link between the two locations is not reliable during the daytime due to snared bandwidth which replication should you recommend to meet this customer's needs?
- A. Asynchronous Periodic
- B. Asynchronous Streaming
- C. Synchronous
- D. 3DC Peer Persistence
Answer: A
NEW QUESTION 52
A startup company is considering an HPE Nimble solution. They have a small IT budget, and they need to be future-proof for changing performance requirements. How does the Nimble architecture meet the company needs? (Select two.)
- A. Support for FCoE
- B. non-disruptive technology refresh
- C. native support for block and file services
- D. ability to mix-and-match All flash and hybrid nodes
- E. minimal downtime technology refresh
Answer: A,D
NEW QUESTION 53
A customer needs to prevent a Fibre Channel switch from being connected to the current SAN infrastructure and accidentally joining the fabric.
What should be implemented on the customer SAN switches to prevent this occurrence?
- A. DH-CHAP
- B. IPFilter
- C. Switch connection control
- D. Fabric configuration server
Answer: A
NEW QUESTION 54
How does the HPE Storage strategy support the business need for intelligent storage?
- A. It reorganizes data patterns in a way that eliminates the requirement for dedicated storage arrays, freeing valuable rack space for other uses.
- B. It Integrates the entire storage product portfolio into a Federated Storage Array capable of hosting any customer workload.
- C. It matches customer workloads with the best available resources, while autonomously monitoring the storage environment for issues before they become problems
- D. It enables customers to move workloads seamlessly between resources from all vendors, while maintaining data integrity and performance at the highest level.
Answer: C
NEW QUESTION 55
Refer to the exhibit.
A customer has the environment shown. They currently perform application-consistent daily full backups via Veeam backup to an HPE StoreOnce device. These backups are then replicated to an alternate device using Catalyst copy.
Changing business requirements have mandated the RPO and RTO for the customer's SQL databases be reduced to 15 minutes. Due to the size of the databases, it is not possible to meet this requirement with their existing backout application.
What should you recommend the customer implement in order to meet their new requirement?
- A. HPE 3PAR Remote Copy in Synchronous Mode
- B. HPE RMC Express Protect
- C. HPE 3PAR Remote Copy in Asynchronous Streaming Mode
- D. SPE StoreOnce Cloud Bank
Answer: C
NEW QUESTION 56
A customer has a primary site with an HPE Nimble Storage array and a secondary site with another HPE Nimble Storage array. The customer had a planned power outage at their primary site, and now needs to switch back to the primary array.
Place the steps into the order they must be performed to switch back the primary array.
Answer:
Explanation:
NEW QUESTION 57
A customer has a solution from another vendor. The customer ran into issues of a disproportionally high failure rate of media keeping logfile dat A.
The issue also appeared in the second array, to which the data is being replicated.
The customer specifically asks you for a solution that will not have this same issue. Which feature of HPE
3PAR arrays should you emphasize?
- A. wide striping data across controllers and disks
- B. ASIC accelerated thin provisioning
- C. inline compression and data packing
- D. creating snapshots on different physical disks
Answer: C
NEW QUESTION 58
You are designing an HPE 3PAR replication solution for a customer in a metropolitan area that includes two main sites and a third disaster recovery site. The main sites will be in synchronous replication. The disaster recovery site can be asynchronously replicated.
What are two points you should highlight to the customer? (Select two.)
- A. Tertiary site volume paths are active/read only
- B. Secondary site volumes paths are active/optimized read/write
- C. Primary site volumes paths are standby read/write
- D. Quorum Witness at the third site enables automatic failover to the secondary site
- E. Quorum Witness at the third site enables automatic failover to tertiary site
Answer: A,D
NEW QUESTION 59
A customer has a two-node HPE 3PAR array with three additional drive enclosures. There is a single CPG setup for RAID 5 (3+1). One of the drive enclosures has failed and must be replaced.
What needs to be considered before starling the repair?
- A. HA cage availably will be lost during the enclosure replacement process.
- B. A node rescue will need to be performed after the enclosure replacement.
- C. The enclosure I'O modules will need to be paired with the replacement enclosure
- D. The array must be powered down to perform the enclosure replacement.
Answer: A
NEW QUESTION 60
Refer to the exhibit.
A customer asks you to design an HPE 3PAR 9450 solution with 64 3 84 TB SSDs using RAID 6 (6+2). The customer does not want to lose data It an entire drive enclosure Is lost
What must be added to the Bill of Materials shown to meet these requirements?
- A. 4 HPE 3PAR 9000 24-disK 2U SFF (2 5ln) SAS Drive Enclosure
- B. 1 HPE 3PAR Policy Manager Software E-LTU
- C. 1 HPE 3PAR StoreServ RPS Service Processor
- D. 8 HPE External 2.0m(6ft) Mini-SAS HD 4x to Mini-SAS HD 4x Cable
Answer: A
NEW QUESTION 61
Click and drag the steps on the left into the appropriate order on the right to set up an HPE 3PAR array in InfoSight.
Answer:
Explanation:
NEW QUESTION 62
A customer has a requirement to provide disaster recovery for an application. The application has an RPO of
30 mins, with an RTO of 15 mins. How can HPE 3PAR Remote Copy help meet the customer's specified requirements in the most cost effective manner?
- A. by using Streaming Asynchronous replication with an interval of 15 mins
- B. by using Synchronous Long Distance Mode
- C. by using Periodic Asynchronous Replication with an interval of 15 mins
- D. by using Synchronous Replication
Answer: D
Explanation:
Explanation
NEW QUESTION 63
A customer has a requirement to provide disaster recovery for an application. The application has an RPO of
30 mins, with an RTO of 15 mins. How can HPE 3PAR Remote Copy help meet the customer's specified requirements in the most cost effective manner?
- A. by using Streaming Asynchronous replication with an interval of 15 mins
- B. by using Synchronous Long Distance Mode
- C. by using Synchronous Replication
- D. by using Periodic Asynchronous Replication with an interval of 15 mins
Answer: D
NEW QUESTION 64
A customer recently acquired another company located less than three km from their current main location.
Both locations use HPE D-Series products in their storage environments.
The customer needs to merge the two locations while still using the current WAN and networking infrastructure at both locations. They need to Keep the initial cost down until they are able to redesign both networking infrastructures When providing a proposal, which protocol should be incorporated to meet the customer needs?
- A. DWDM
- B. CWDM
- C. ISCSI
- D. FCIP
Answer: B
NEW QUESTION 65
A customer has a pair of HPE 3PAR arrays with Synchronous Replication enabled. They need recommendations for deploying the Quorum Witness when implementing Peer Persistence.
What should you recommend to the customer?
- A. The Quorum Witness should be in the primary data center, with FC connectivity to the HPE 3PAR there
- B. The Quorum Witness should be in a third data center, with IP connectivity to both HPE 3PARs
- C. The Quorum Witness should be in the secondary data center, with IP connectivity to the HPE 3PAR there
- D. The Quorum Witness should be in a third data center, with FC connectivity to both HPE 3PARs
Answer: D
NEW QUESTION 66
You are discussing a HPE 3PAR Remote Copy solution with your customer. The customer has had a bad experience in their current non-HPE replication solution. Currently the source and target volume properties on the array must be identical on both sides and cannot be changed without re-creating the volumes.
What should you explain to the customer?
- A. Source and target disk type and RAID level can be different and adapted to changing requirements
- B. On the target array volumes can be pinned into cache for maximum flexibility
- C. All data from the source array will automatically be replicated to the target array using AI to determine the best location where to store the data
- D. Flash data can only be replicated to flash media on the target array, while spinning media can be replicated to flash media
Answer: D
NEW QUESTION 67
A customer needs to replicate the data on their HPE 3PAR arrays between their datacenters. Their datacenters are 250km apart. The link between the sites has an RTO of 100 ms, and they have an RPO of 3 minutes.
Which replication method should you recommend to meet the customer needs?
- A. RCIP in Asynchronous Streaming mode
- B. RCIP is Synchronous mode
- C. RCFC is Synchronous mode
- D. RCFC in Asynchronous Periodic Mode
Answer: D
NEW QUESTION 68
......
HPE0-J58 Dumps Full Questions with Free PDF Questions to Pass: https://www.pass4guide.com/HPE0-J58-exam-guide-torrent.html
HPE0-J58 PDF Recently Updated Questions Dumps to Improve Exam Score: https://drive.google.com/open?id=1OtaAoWqKHxMEL2yK3XchZDlVZfvgB2of